
The loft bed that I built in 2009 needs to be reconfigured, removing the “loft” from it. We began by disassembling the bed. I then cut down each of the four legs to allow…
The closet organizer is complete. In total it took three weekends, but only a few hours each weekend day. I was a little over zealous when ripping the sheets of melamine and had to glue a couple pieces together to…
Drawer assembly is complete! Installed the drawer slides and drawer pulls. Rabbeted the bottom of the drawer to accept a 1/4″ piece of luan plywood. The corners of the luan had to be rounded because the rabbet was cut out…
Started work on the drawers. The make the process a bit easier, I create a simple right-angle jig to hold components secure when fastening with the pocket hole screws. The sides are inset by 1/4″ on either side, so I…
With the shelving section completed, I’ve begun work on the drawer unit. I completed the carcass, and cut the drawer components, but have not yet put the drawers together.
Looking through an old copy of boot magazine and found this LCD review.. prices have come down a bit!